ASTM **C1583** is the American Society of Testing and Materials document entitled, "Standard Test Method for Tensile Strength of Concrete Surfaces and the Bond Strength or Tensile Strength of Concrete Repair and Overlay Materials by Direct Tension" (Pull-off Method)," 2004 (ASTM **C1583**-04).

18 Shotcrete • Winter 2005 Testing Shotcrete for Bond by Edward Brennan M uch is written about the requirements for materials (sand, aggregates, cement and admixtures), equipment, placement methods (wet versus dry), and personnel with respect to the shotcrete process.

BOND-TEST 15 Purpose The BOND-TEST is used to conduct a pull-off test in accordance with ASTM **C1583**, "Test Method for Tensile Strength of Concrete Surfaces and the Bond Strength or Tensile Strength of Concrete Repair and Overlay Materials by Direct Tension (Pull-off Method)."

Use prope r repair techniques to replace unsound COMMON WORK RESULTS FOR CONCRETE03 05 00 The QUIKRETE Companies ® QUIKRETEª Concrete Bonding Adhesive #9902 TABLE 1 TYPICAL TENSILE BOND STRENGTHS TO CONCRETE SUBSTRATES (ASTM **C1583**) Application Tensile bond strength Sand Mix bonded with paint-on adhesive 7 ...

... mix fluid Laboratory Tests Results Compressive strength - ASTM C109 24 hours > 1,740 psi (12 MPa) 7 days > 2,610 psi (18 MPa) 28 days > 3,625 psi (25 MPa) Flexural strength - ASTM C348 24 hours > 522 psi (3,6 MPa) 7 days > 986 psi (6,8 MPa) 28 days > 1,196 psi (8,25 MPa) Adhesion (tensile strength) - ASTM **C1583** 7 ...

... Adhesion of Organic Coatings to Plastic Substrates by Direct Tensile Testing ASTM E736-00Standard Test Method for Cohesion/Adhesion of Sprayed Fire-Resistive Materials Applied to Structural Members ASTM C633-01Standard Test Method for Adhesion or Cohesion Strength of Thermal Spray Coatings ASTM **C1583**-04 ...

How Proceq's instruments are trusted tools for Material Testing Laboratories worldwide A STM **C1583** / C1583M. This specification covers standard test method for tensile strength of concrete surfaces and the bond strength or tensile strength of concrete repair and overlay materials by direct tension (pull ...

Tensile Bond to Concrete (ASTM **C1583**) At 7 days 0.8 MPa (116 psi) At 28 days 1.4 MPa (200 psi) INSTALLATION SURFACE PREPARATION

... Compressive*strength*-*ASTM*C349 24*hours* >*815*psi* (5,62*MPa) 7 days >*2,900*psi* (20*MPa)* 28*days >*3,500*psi* (24,1*MPa) Flexural*strength*-*ASTM*C348 24*hours >*310*psi* (2,14*MPa) 7 days >*990*psi* (6,83*MPa)* 28*days >*1,210*psi* (8,34*MPa) * Adhesion* (tensile*strength)*-*ASTM***C1583** 7 days >*325*psi* (2 ...

The bonding capacity of the prepared surface can be randomly checked using a direct tensile pull-off test (Fig. 8) as described in ICRI Technical Guideline No. 210.3, "Guide for Using In-Situ Tensile Pull-Off Tests to Evaluate Bond of Concrete Surface Materials," and ASTM **C1583**/C1583M, "Standard Test ...