Sputtr.com | Alternative Search Engine

Crimp

THE CRIMPING PROCESS

TERMS & DEFINITIONS Crimp or Crimping Sleeve: Machined hollow sleeve used to secure the hollow end of the spectra to mono that's been worked up into the spectra.

QUALITY CRIMPING HANDBOOK

Quality Crimp Handbook Order No: TM-638000029 Release Date: 09-04-03 UNCONTROLLED COPY Page 3 of 24 Revision: D Revision Date: 12-23-09 SECTION 1 INTRODUCTION TO CRIMP TECHNOLOGY Developed to replace the need to solder terminations, crimping technology provides a high quality connection between ...

Crimp Height— - Employing the Most Effective Crimp Quality ...

Crimp Height— Employing the Most Effective Crimp Quality Metric for Meeting Contemporary Quality Standards Driven by the requirements of 6-Sigma and other international quality

QUALITY CRIMPING HANDBOOK

INTRODUCTION TO CRIMP TECHNOLOGY Developed to replace the need to solder terminations, crimping technology provides a high quality connection between a terminal and a wire at a relatively low applied cost.

Crimp Quality Monitor 1320420-2

Customer Manual 409–10007 LOC B 1 of 61 1999 AMP Incorporated, Harrisburg, PA. All International Rights Reserved. *Trademark TOOLING ASSISTANCE CENTER 1–800–722–1111

Crimping Instructions

Step 2 string on a crimp tube (and, if you choose, the small bead discussed above) and part of your clasp. Step 3 Lead the wire back through the small bead (if you used one), the crimp tube, and then through two or three more beads.

CRIMPING, INTERCONNECTING CABLES, HARNESSES, AND WIRING

Individual Shield Termination Using a Heat Shrinkable Solder Sleeve 11.5 Individual Shield Termination Using Two-Piece Crimp Rings An individual shield that is terminated using two-piece crimp rings (ferrules) to attach grounding wires to the shield braid is shown in Figure 11-3.

CERTI-CRIMP*II Straight Action Hand Tools

Instruction Sheet 408--8547 LOCB 1 of4 E2011 TycoElectronics Corporation, aTE Connectivity Ltd. Company All RightsReserved *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.

Precaution for Crimping Process

As crimping terminals without the correct crimp-height is the cause of poor conductivity, measure the crimp-height at the start, in the middle and at the end of the crimping process.

Company Profile

www.crimp.com.au Crimp (Aust) Proud to be an INTEL CCD Member. P.O. Box 4029 KOGARAH BAY NSW 2217 Phone: 0285675333 Facsimile: 0285675353 Email: rossg@crimp.com. au Company Profile Borge Pedersen AS, an engineering firm in Denmark, started Borge Pedersen (Aust) Pty Ltd in 1986.