Sputtr.com | Alternative Search Engine

Falsework

03 11 14 - Falsework

SECTION 03 11 14 FALSEWORK PART 1 - GENERAL 1.01 SECTION INCLUDES A. Layout of falsework. B. Falsework construction. C. Removal of falsework. 1.02 MEASUREMENT AND PAYMENT A. Measurement: Falsework for concrete structures will not be measured separately for payment.

3 Forms, Falsework, and Reinforcement

3-1 CHAPTER THREE: FORMS, FALSEWORK, AND REINFORCEMENT This chapter includes information on the inspection of two activities common to the construction of a bridge substructure: the erection of forms and falsework, and the installation of reinforcing steel.

FALSEWORK AND FORMWORK

FALSEWORK AND FORMWORK (4-1-11) 1.0 D ESCRIPTION Use this Special Provision as a guide to develop temporary works submittals required by the Standard Specifications or other provisions; no additional submittals are required herein.

CIS56 - Safe erection, use and dismantling of falsework

HSE information sheet Introduction Falsework is any temporary structure used to support a permanent structure while it is not self-supporting, either in new construction or refurbishment.

Avoiding Falsework Failure

www.PDHcenter.com PDH Course G153 www.PDHonline.org Page 1 of 10 Avoiding Falsework Failure Course Content Falsework failure can be a catastrophic collapse; destroying property and killing people.

TIP sheet T013 - Formwork and falsework

Minimum requirements Managers and Supervisors must identify, register, risk assess and then eliminate or minimise all risks associated with formwork to as low as reasonably practicable prior to work being commenced.

708 - FALSEWORK AND FORM CONSTRUCTION

708 - FALSEWORK AND FORM CONSTRUCTION SECTION 708 FALSEWORK AND FORM CONSTRUCTION 708.1 DESCRIPTION Design and construct safe, adequate falsework to provide the necessary rigidity, support the loads imposed and produce the final structure to the lines and grades shown in the Contract Documents.

Kiewit Bridge & Marine Best Safety Practices and Safety ...

Kiewit Bridge & Marine Best Safety Practices and Safety Policy Manual 11/06 Section 2.13 / Falsework and Shoring Safety Page 1 of 13 SECTION 2.13 FALSEWORK AND SHORING SAFETY Policy For purposes of this policy, falsework and shoring safety shall include bridge falsework, bridge overhang systems ...

5.4 Drilled Shafts.book

Kansas Department of Transportation Bridge Construction Manual Version 9/09 KDOT Bridge Section 6.0 -Forms and Falsework - i 6.0 Forms and Falsework Table of Contents 6.0 TEMPORARY STRUCTURES .....1 6.0.1 General ...

Falsework - Prevention of Collapse

This Guidance Notes is prepared by the Occupational Safety and Health Branch Labour Department First Edition November 1998 This Guidance Notes is issued free of charge and can be obtained from offices of the Occupational Safety and Health Branch, Labour Department.